Characterization and superhydrophilicity properties of TiO2 composites modified with graphene oxide and carbon nanotubes, and self-cleaning of TiO2 and GO-TiO2 composite fabricated via sol–gel
Materials Research Express, cilt.13, sa.21, 2026 (SCI-Expanded, Scopus)
- Yayın Türü: Makale / Tam Makale
- Cilt numarası: 13 Sayı: 21
- Basım Tarihi: 2026
- Doi Numarası: 10.1088/2053-1591/aeb7c5
- Dergi Adı: Materials Research Express
- Derginin Tarandığı İndeksler: Science Citation Index Expanded (SCI-EXPANDED), Scopus, Chemical Abstracts Core, Compendex, INSPEC, Directory of Open Access Journals, Materials Science & Engineering Collection (ProQuest), Technology Collection (ProQuest)
- Anahtar Kelimeler: carbon nanotubes, graphene oxide, self-cleaning, superhydrophilicity, TiO2
- Açık Arşiv Koleksiyonu: AVESİS Açık Erişim Koleksiyonu
- İstanbul Üniversitesi Adresli: Evet
Özet
In this study, titanium dioxide (TiO2) and modified with graphene oxide (GO) and carbon nanotubes (CNTs) were prepared via sol–gel method. GO and CNT dispersions in ethanol were mixed with TiO2 sol, deposited on Corning glass substrates by spin coating, dried at 250 °C and then annealed at 500 °C. Structural, morphological and surface properties of the composites were investigated for both GO-TiO2 and CNT-TiO2 by x-ray diffraction (XRD), Atomic force microscopy (AFM) and contact angle measurements. XRD confirmed the anatase phase in all samples. AFM showed that GO-TiO2 exhibited significantly higher average surface roughness (Ra, average surface roughness, up to 15.061 nm) compared to CNT-TiO2 (Ra ≈4 nm) and unmodified TiO2 (Ra = 2.142 nm). Contact angle measurements revealed superhydrophilic surfaces for both GO-TiO2 (contact angles as low as 1°) and CNT-TiO2 reached (4°), while TiO2 showed 7°. Based on these results, GO-TiO2 was selected for self-cleaning application. Photocatalytic self-cleaning performance was evaluated for GO-TiO2 composite and compared with unmodified TiO2. TiO2 was tested under ultraviolet (UV) light due to its wide band gap (3.25 eV), while GO-TiO2 was tested under natural daylight owing to its visible-light absorption (band gap ∼2.95 eV). The optimal GO-TiO2 (GO0.08-TiO2) achieved complete methylene blue degradation within 35 min under natural daylight, whereas TiO2 required 60 min under UV irradiation. These results demonstrate that GO modification enables visible-light-activated self-cleaning performance without requiring UV light sources.